Configure RAID in Legacy Boot Mode
The RAID Configuration Confirmation screen appears.
13.
To confirm your RAID configuration, select Confirm and then select Yes.
The Confirmation screen appears.
14.
Select OK to continue.
15.
Press F10 to save your changes and exit.
This completes the RAID configuration. You can now install an operating system on the volume
that you have created.
Configure RAID in Legacy Boot Mode
Use this task to create a logical drive on an x86 system in legacy boot mode, and to define it as
bootable. This prepares the drive so that you can install an operating system onto it.
Configuring Storage Drives for Operating System Installation 111
To Next Page
Loading...
