Oracle Server X6-2 User Manual

Modify Oracle ILOM SP Network Settings
■ From the CLI:
a.
To view the assigned IPv4 and IPv6 network settings on the SP, perform
the following:
For IPv4, type: show /SP/network
For IPv6, type: show /SP/network/ipv6
b.
To view the descriptions about each IPv4 and IPv6 network property,
perform the following:
For IPv4, type: help /SP/network
For IPv6, type: help /SP/network/ipv6
c.
To modify the IPv4 and IPv6 network properties on the SP, issue the set
command.
IPv4 Example:
set /SP/network state=enabled|disabled pendingipdiscovery=static|dhcp
pendingipaddress=value pendingipgateway=value pendingipnetmask=value
IPv6 Example:
set /SP/network/ipv6 state=enabled|disabled pending_static_ipaddress=
value/subnet_mask_value pending_static_ipgatewayaddress= value
Note - A dual-stack network connection is enabled when both the IPv4 and IPv6 State
properties are set to enabled. By default, Oracle ILOM is factory-configured with network
settings enabled for a dual stack (IPv4 and IPv6) network connection. If the IPv4 State property
is enabled (SP/network state=enabled), and the IPv6 State property is disabled (SP/network
state=disabled), Oracle ILOM supports an IPv4-only network connection.
d.
To commit the IPv4 and IPv6 pending network changes in Oracle ILOM,
type:
set /SP/network commitpending=true
Note - All user sessions on the SP are terminated upon committing the IP network property
changes. To log back in to Oracle ILOM, use the newly assigned service processor IP address.
86 Oracle Server X6-2 Installation Guide • July 2020

Oracle Server X6-2 Specifications

General

Brand	Oracle
Model	Server X6-2
Category	Server
Language	English