5 - 34
HANDLEBER
8. Install:
Brake master cylinder ①
Brake master cylinder bracket ②
Bolt (brake master cylinder bracket) ③
NOTE:
Install the bracket so that the arrow mark b
faces upward.
First tighten the bolt on the upper side of the
brake master cylinder bracket, and then
tighten the bolt on the lower side.
9. Install:
Engine stop switch ②
Bolt (clutch lever holder) ③
Screw (Engine start button) ①
T
R
.
.
9 Nm (0.9 m • kg)
T
R
.
.
9 Nm (0.9 m • kg)
T
R
.
.
4 Nm(0.4 m • kg)
10. Install:
NOTE:
Apply the lithium soap base grease on the
clutch cable end .
11. Adjust:
Clutch lever free play
Refer to “CLUTCH ADJUSTMENT”
section in the CHAPTER 3.
Hot starter lever free play
Clutch lever holder ④
Engine start button ①
Bolt (clutch lever) ①
To Next Page
Loading...