Chapter 1 Introduction to Your Handheld
10
To remove the face plate:
1.
Remove the flip cover.
2.
Lift the face plate tab slightly to separate it from your handheld and pull the
existing face plate away from your handheld.
To attach the face plate:
1.
Align the bottom edge of the new face plate with the slot on the bottom edge of
your handheld.
2.
Gently press the top of the face plate onto your handheld until it clicks into
position.
Connecting the HotSync cradle/cable
IMPORTANT
The HotSync cradle/cable supplied with your handheld fits a USB
connector. If your computer does not have a USB port, or if you are using
Windows 95, Windows NT, or an older Mac computer, you can order a serial cradle/
cable and a 25-pin serial adapter, if necessary, from www.palm.com. Follow the
documentation that accompanies the serial cradle/cable before attempting to
complete the installation tasks.
To connect the HotSync Cradle/cable
1.
Shut down and turn off your computer.
2.
Plug the USB connector on the cradle/cable into a USB port on your computer.
Face plate tab
1
2
To Next Page
Loading...
Need help?
General
