Preparing to use your handheld
11
3.
Connect the power cord that attaches to the back of the cradle’s USB port
connector to the AC adapter cord.
4.
Plug the adapter into any AC current outlet.
Charging the handheld
Your handheld is recharged each time you place the handheld in the cradle. Just
place your handheld in the cradle for at least two hours for an initial charge before
you use it. Then place it in the cradle for ten to fifteen minutes each day to recharge
the battery to full capacity.
If the battery gets low, your handheld displays a warning message. If this occurs,
perform a HotSync operation and then recharge the battery as soon as possible. If
your handheld shuts down, you still have about a week to recharge the battery
before you lose the data on your handheld.
To Next Page
Loading...
Need help?
General
