Panasonic AAD03011 - Page 42

No. 
ڎ 0࡮ 0.1㨪999 0.5
ڎ 0࡮ 0.1㨪999 0.5
ڎ 0࡮ 0.1㨪999 0.5
ڎ 0࡮0.1㨪999 0.5
ڎ 0࡮0.1㨪999 0.5
ڎ 0࡮0.1㨪999 1.2
ڎ 0࡮0.1㨪999 0.6
ڎ
d40
0.0㨪100
0.5
ڎ
d41
0.0㨪100
0.5
ڎ
d42
0࡮0.1㨪999
0
ڎ
d43
0.5㨪250
0.5
ڎ
d44
0.5㨪250
0.5
ڎ
d45
0.0㨪10
0.5
ڎ
d46
0.0㨪10
0.5
ڎ
d47
0.0㨪3.0
ڎ
d48
0.0㨪3.0
ڎ
d49
0.0㨪3.0
ڎ
d50
0.0㨪3.0
ڎ
d51
0࡮0.5㨪250
3
ڎ
d52
0.5㨪250
2
ڎ
d53
0࡮1㨪999
000
Note1) The䃨indicates parameters that can be changed during the inverter
is in operation.
40
d33
d34
d35
d36
d37
d38
d39
0
0
0
0
Parameter name
Setting range
Factory
setting
data
Acceleration/deceleration time 6 (s) OPEN
Acceleration/deceleration time 1 (s) CLOSE
Acceleration/deceleration time 2 (s) CLOSE
Acceleration/deceleration time 3 (s) CLOSE
Acceleration/deceleration time 4 (s) CLOSE
Acceleration/deceleration time 5 (s) CLOSE
Acceleration/deceleration time 6 (s) CLOSE
OPEN Hold current (A)
CLOSE Hold current (A)
STOP time of Open/Close hold operation (s)
OPEN arrival hold wait frequency (Hz)
OPEN arrival hold wait time (s)
CLOSE arrival hold wait time (s)
CLOSE
arrival hold wait frequency (Hz)
OPEN breakaway timer (SW mode) (s)
OPEN deceleration timer (SW mode) (s)
CLOSE breakaway timer (SW mode) (s)
CLOSE deceleration timer (SW mode) (s)
Operation frequency when power supply is turned ON (Hz)
Door width measurement frequency (Hz)
Password setting in d area
Fault CLOSE operation frequency 1 (Hz)
Fault CLOSE operation frequency 2 (Hz)
Fault CLOSE operation frequency 3 (Hz)
Fault CLOSE operation frequency 4 (Hz)
Fault CLOSE operation frequency 5 (Hz)
Fault CLOSE operation frequency 6 (Hz)
Fault CLOSE operation acceleration/deceleration time 1 (s)
Fault CLOSE operation acceleration/deceleration time 2 (s)
Fault CLOSE operation acceleration/deceleration time 3(s)
Fault CLOSE operation acceleration/deceleration time 4 (s)
Fault CLOSE operation acceleration/deceleration time 5 (s)
Fault CLOSE operation acceleration/deceleration time 6 (s)
d54
4
d55
d56
d57
d58
d59
d60
d61
d62
d63
d64
d65