- 124 -
≥
is displayed beside the display of the SD card selected as the recording destination of
motion pictures in [MEDIA SELECT] (l 37). When the recording media is switched and Relay
Recording starts, will disappear from the location and instead be displayed beside the
other SD card display.
≥ Even after switching of the recording media, you can replace the SD card that ran out of space
with a new one and record the motion picture onto three or more SD cards. Since it may take a
while for this unit to recognize a new SD card, replace the SD card that ran out of space when the
SD card currently being used as a destination still has sufficient remaining recordable time.
≥ The maximum recording time for Relay Recording is 10 hours.
≥ When the recording time of Relay Recording reaches 10 hours, the recording will stop
temporarily. It will restart automatically a few seconds later.
∫ Simultaneous recording
Same motion picture can be recorded on two SD cards.
≥ is displayed beside the display of the SD card selected as the recording destination of
motion pictures in [MEDIA SELECT] (l 37).
≥ If you set the recording destination of motion pictures to [SD CARD 1] in [MEDIA SELECT], they
will also be recorded to [SD CARD 2] simultaneously.
≥ We recommend that you perform simultaneous recording using SD cards of the same Speed
Class rating and capacity.
(Relay recording)
≥ Destination to record still pictures will be switched to other SD card after performing the relay
recording. In addition, a message about the remaining card capacity will be displayed. Replace
the SD card that ran out of space or set [2 SLOTS FUNC.] to [OFF].
(Simultaneous recording)
≥ Simultaneous recording will not be performed for still pictures.
1 Recording is started
2 Recording is paused
A Recording
B The card slot used for recording is switched automatically.
C Replace the SD card with a recordable one.
1 Recording is started
2 Recording is paused
A Recording
RELAY
R68S3_PJPB.book 124 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
