- 64 -
You can set the initial time code.
1 Select the menu.
2 Touch the item to set and change with / .
≥ It will be set to 00h00m00s00f when the [Reset] is touched.
≥ “h” is an abbreviation for hour, “m” for minute, “s” for second and “f” for frame.
3 Touch [EXIT] to complete the setting.
≥ This unit will adjust the time code in accordance with the frame rate of the [REC FORMAT]
(l 116). Therefore, it may not be continuous from the previous final time code when the
recording format is changed.
≥ If the frame rate in [REC FORMAT] is set to 23.98p, set the number of frames to [00] or a multiple
of 4. If you enter a different value, time code will not be recorded correctly.
Setting the Recording Counter
Recording Counter will display the recording time in seconds.
0:00:00 (hour : minute : second (When [REC COUNTER] is set to [TOTAL]))
SCN 0:00:00 (hour : minute : second (When [REC COUNTER] is set to [SCENE]))
Select the counting method during the recording.
Select the menu.
To reset the Recording Counter for the Recording
Mode
The Recording Counter will be set to 0:00:00 when is
touched while displaying the counter.
[TC PRESET]
: [RECORD SETUP] # [TC PRESET]
[REC COUNTER]
: [DISP SETUP] # [REC COUNTER] # desired setting
[TOTAL]: The count continues to increase until the Recording Counter is reset.
[SCENE]: Resets the Recording Counter at start of recording. Counts the time
of each recording session.
MENU
MENU
RESET COUNT
DISP/
MODE
O.I.S. BARS
ZEBRA
R68S3_PJPB.book 64 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
