- 75 -
≥ Register “Level Shot Function” to a USER button. (l 65)
This function detects the horizontal tilt of the unit, and automatically corrects it to the level position.
≥ is displayed on the screen.
≥ The icon changes when the tilt exceeds the correction range.
≥ When the tilt exceeds the correction range, move the unit to the position where is displayed.
≥ This function is not available in the following cases:
j During Super Slow Recording (l 76)
≥ The setting of this function cannot be changed during Freeze Frame. (l 71)
≥ [LEVEL GAUGE] turns off if you set [LEVEL SHOT] to [ON]. Conversely, [LEVEL SHOT] turns off
if you set [LEVEL GAUGE] to [ON].
≥ The range that this icon can be displayed correctly the slope is about 45 o to the horizontal
direction.
≥ The image may move while zooming depending on the tilt of this unit.
≥ When recording horizontal images using a tripod, attach the unit on the tripod using [LEVEL
GAUGE], and set [LEVEL GAUGE] to [ON] again.
≥ Register “Flash band compensation” to a USER button. (l 65)
≥ Switch to Manual Mode. (l 42)
If you set this item to [ON], you can compensate for and reduce flash band, a phenomenon that
creates markedly different levels of luminance between the top and bottom of the image when
recording is performed in an environment where another camera is firing its flash.
≥ FBC appears on the screen.
≥ This function is not available in the following cases:
j When the frame rate in [REC FORMAT] is 29.97p or 23.98p (l 116)
j When a setting in [SCENE MODE] is enabled (l 112)
j When using [DIGITAL ZOOM] (l 69)
j During Super Slow Recording (l 76)
≥ The setting will be turned off in the following cases:
j If you turn the unit off
j If you press the THUMBNAIL button
j If you switch to Intelligent Auto Mode
j When [USB MODE SELECT] is set to [DEVICE] and this unit is connected to a PC. (l 103)
≥ This function will fix the shutter speed to 1/60. The shutter speed cannot be adjusted.
≥ Register “PRE-REC” to a USER button. (l 65)
This allows the recording of an image and audio to start before you press the recording start/stop
button. AVCHD scenes will be recorded from approximately 3 seconds before the operation, while
MOV/MP4 will be recorded from approximately 4 seconds before the operation.
Level Shot Function
When the tilt is corrected
/
When the tilt is above the correction range
Flash band compensation
PRE-REC
R68S3_PJPB.book 75 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
