- 48 -
Focus Assist
You can use Focus Assist by pressing the USER button to which [FOCUS ASSIST 1] or [FOCUS
ASSIST 2] is registered.
≥ For information on how to set the USER buttons, refer to page 65.
≥ [FOCUS ASSIST 1] is registered to the USER4 button by default.
∫ To select the Focus Assist method for the USER button to which
[FOCUS ASSIST 1] is registered
Select the menu.
∫ To select the Focus Assist method for the USER button to which
[FOCUS ASSIST 2] is registered
Select the menu.
≥ You can use the magnified display and the peaking function separately or use them in
combination by selecting different settings for [FOCUS ASSIST 1] and [FOCUS ASSIST 2].
≥ If [FOCUS ASSIST 1] is set to [BOTH], [FOCUS ASSIST 2] is not available. In addition, the USER
button to which [FOCUS ASSIST 2] is registered is disabled.
Selecting a Focus Assist method
: [SW SETUP] # [FOCUS ASSIST 1] # desired setting
[EXPAND]: Magnifies the central area of the screen when Focus Assist is used.
[PEAKING]: Highlights in-focus portions with color when Focus Assist is used.
[BOTH]: Sets both [EXPAND] and [PEAKING].
: [SW SETUP] # [FOCUS ASSIST 2] # desired setting
[EXPAND] / [PEAKING]
Using Focus Assist
≥ Register [FOCUS ASSIST 1] or [FOCUS ASSIST 2] to a USER button. (l 65)
≥ Switch to Manual Focus Mode. (l 46)
Press the USER button to which [FOCUS ASSIST 1] or [FOCUS ASSIST 2] is
registered or touch the applicable USER button icon.
≥ To turn off Focus Assist, perform the following operations:
j Press the USER button again, or touch the USER button icon again.
j Touch [EXIT].
R68S3_PJPB.book 48 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
