- 45 -
Even in dark locations, you can record brighter scenes by turning on the built-in LED light.
Slide the LED LIGHT switch to turn on the built-in LED light.
≥ Do not look at the light-emitting portion of the built-in LED light directly while the light is turned on,
or bring the portion close to someone’s eyes and turn on the light.
≥ The recordable time with the battery becomes shorter with the use of the built-in LED light.
≥ The White Balance mode [ATW] may not work correctly while the built-in LED light is turned on,
depending on recording conditions. In this case, switch to Manual Mode and adjust the White
Balance.
(l 51)
≥ When the battery becomes low, the built-in LED light may turn off or may not turn on.
∫ Using the supplied filters for the built-in LED light
Using the diffusion filter
The supplied diffusion filter softens the light by reducing its glare.
Use the diffusion filter when the built-in LED light is too bright.
Using the color conversion filter
The supplied color conversion filter lowers the color temperature of the built-in LED light.
Use the color conversion filter when the color temperature of the recording environment is low or
when you want to lower the color temperature of the built-in LED light.
≥ When using the color conversion filter, switch to Manual Mode and adjust the White Balance
before recording.
Attaching/removing the filters for the built-in LED light
≥ Push in until a clicking sound is heard.
≥ Hold both the left and right sides of the filter to remove it.
Recording
Using the Built-in LED Light
(How to attach/detach the filter)
ONOFF
LED LIGHT
LED LIGHT switch
Slide the switch to turn on/off the built-in
LED light.
ON: Turned on
OFF: Turned off
R68S3_PJPB.book 45 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
