- 65 -
Each of the USER button can register one function from the 28 available functions.
≥ There are 5 USER buttons (USER1 to 5) on the main body and 4 USER button icons (USER6 to
USER9) displayed on the LCD monitor.
Setting the USER button
1 Select the menu.
≥ It is not possible to register functions to [USER6] to [USER9] in Playback Mode.
2 Touch the item to register.
≥ For the functions of the USER button that can be registered, refer to page 66.
≥ Touch [INHIBIT] if not registering.
≥ Next (Previous) page can be displayed by touching / .
3 Touch [EXIT] to complete the setting.
≥ The tables below show the default settings.
≥ Performing [YES] in [INITIAL SET] restores these default settings. (l 136)
Using the USER button
To use the function assigned to a USER button or USER button icon, press the applicable USER
button (one of the USER buttons 1 to 5), or touch the applicable USER button icon (one of the
USER button icons 6 to 9) while operation icons are displayed.
Recording
USER button
: [USER SW] # [USER1] to [USER9]
USER1 button [LCD/EVF OUTPUT] USER6 button [FRZ FRAME]
USER2 button [BACKLIGHT] USER7 button [EVF/LCD DETAIL]
USER3 button [O.I.S.] USER8 button [ATW LOCK]
USER4 button [FOCUS ASSIST 1] USER9 button [MENU]
USER5 button [REC CHECK]
(When you use the USER1 to USER4 button) (When you use the USER5 button)
MENU
LCD/EVF
FOCUS
ASSIST
14
B.LIGHT
2
O.I.S.
3
R68S3_PJPB.book 65 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
