- 122 -
You can set the peaking strength for Focus Assist. (l 50)
≥ This function’s default setting is “0”.
You can set an Area Mode effect. (l 72)
This sets the display duration of the zebra display.
You can switch the type of color bars to be displayed when you press the BARS button. (l 80)
Enable/disable of the sub recording start/stop button on the handle can be switched.
Enable/disable of the sub zoom lever on the handle can be switched. Zoom speed will be different
depending on the setting.
≥ The larger the value is, the faster the zoom speed becomes, and vice versa.
[PEAKING LEVEL]
[AREA MODE]
[INH]/[FOCUS]/[IRIS]/[Y GET]/[FOCUS/IRIS]/[FOCUS/Y GET]
[ZEBRA MODE]
[CONTINUE]: Displays the zebra display until it is switched to another zebra display setting.
[MOMENT]: Displays the zebra display for approximately 5 seconds.
[BARS TYPE]
[TYPE 1] [TYPE 2] [TYPE 3]
[SUB REC BUTTON]
[INHIBIT]/[ACTIVE]
[SUB ZOOM]
[OFF]/[1]/[2]/[3]/[4]/[5]/[6]/[7]
R68S3_PJPB.book 122 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
