- 50 -
(When changing the peaking color)
Select the menu.
(When setting the peaking strength)
1 Select the menu.
2 Touch / to adjust settings.
≥ You can select a value between s7 and r7.
3 Touch [EXIT] to complete the setting.
(Notes on Focus Assist)
≥ Focus Assist is not possible in following cases:
j During Recording Check (l 70)
j During Freeze Frame (l 71)
j When color bars are displayed. (l 80)
≥ Focus Assist is canceled in following cases:
j If you turn the unit off
j If you press the THUMBNAIL button
j (If you operate the USER button to which [FOCUS ASSIST 1] is registered)
When the setting of [FOCUS ASSIST 1] (l 48) is changed
j (If you operate the USER button to which [FOCUS ASSIST 2] is registered)
When the setting of [FOCUS ASSIST 2] (l 48) is changed
j When you set this unit to Auto Focus
j When [USB MODE SELECT] is set to [DEVICE] and this unit is connected to a PC. (l 103)
≥ The magnified display and peaking are not displayed on recorded images.
≥ The magnified display and peaking are not displayed on a TV.
≥ Freeze Frame is not available when you use Focus Assist. (l 71)
≥ Peaking may not be displayed when you use Digital Zoom (l 69). To zoom in and use peaking at
the same time, we recommend increasing the magnification level of the magnified display by
setting [FOCUS ASSIST 1] to [BOTH] or by using the magnified display and the peaking function
in combination.
(Notes on the peaking function of Focus Assist)
≥ When the EVF/LCD detail function is enabled, Focus Assist is canceled. (l 46)
(Notes on the magnified display of Focus Assist)
≥ Some information on the screen disappears when the screen is magnified.
≥ Still pictures cannot be recorded when the screen is magnified.
≥ In the following cases, the screen is not magnified during Focus Assist:
j During motion picture recording or PRE-REC (l 75, 126)
j When using Digital Zoom
j When using Area Mode (l 72)
j During auto recording (l 78)
j D
uring Super Slow Recording (l 76)
≥ If you set the magnification level of the magnified display to 5.5k or higher, peaking may not be
displayed when using i.Zoom (l 44).
: [SW SETUP] # [PEAKING COLOR] # desired color
[Red]/[Blue]/[Yellow]/[White]
: [SW SETUP] # [PEAKING LEVEL] # desired setting
R68S3_PJPB.book 50 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
