- 46 -
Perform focus adjustments using the focus ring. If auto focusing is difficult due to the conditions,
then use Manual Focus.
≥ Switch to Manual Mode. (l 42)
1 Press the FOCUS A/M/¶ button to enable Manual Focus.
≥ It will switch to MF from AF.
2 Adjust the focus by rotating the focus ring.
≥ The focus value can be set from MF00 (focus distance: approximately 3 cm (1.2 q)) to MF99
(focus distance: infinity). The larger the focus value gets, the further the position where focus is
achieved.
≥ If you press and hold the FOCUS A/M/¶ button, focus will be adjusted to MF95 on the infinity
side.
≥ To return to Auto Focus, press the FOCUS A/M/¶ button or set this unit to Intelligent Auto Mode
using the iA/MANU switch.
≥ When the distance to the subject approaches within 1.5 m (4.9 feet) approx., the unit switches to
the macro range and or . (The unit may switch to the macro range even when the
distance to the subject is 1.5 m (4.9 feet) or more depending on the subject.).
≥ Depending on the zoom magnification, this unit may fail to switch to the macro range, or go to a
non-displayed focus value.
≥ When you perform a zoom operation in the macro range, this unit may go out of focus.
≥ This item cannot be set during Freeze Frame. (l 71)
∫ To emphasize the outline of images
Setting [EVF/LCD DETAIL] to [ON] helps you achieve focus easier by emphasizing the outlines of
an image displayed on the LCD monitor and viewfinder.
You can also adjust the emphasis level or change the frequency.
≥ You can also enable or disable this function with the applicable USER button. (l 73)
≥ These settings will not affect the images actually recorded.
Recording
Focus
: [DISP SETUP] # [EVF/LCD DETAIL] # [ON]
A FOCUS A/M/¶ button
B Focus ring
R68S3_PJPB.book 46 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
