- 73 -
≥ Area Function is not possible in following cases:
j When a setting in [SCENE MODE] is enabled (l 112)
j During Super Slow Recording (l 76)
≥ Area mode is canceled in following cases:
j If you turn the unit off
j If you press the THUMBNAIL button
j If you switch to Intelligent Auto Mode (l 42)
j When the setting of [ASPECT CONVERT] is changed (l 118)
j When [USB MODE SELECT] is set to [DEVICE] and this unit is connected to a PC. (l 103)
≥ When using Area Mode, even if you set [ZEBRA] to [MARKER], the luminance display frame will
not be displayed. (l 81)
In addition, the luminance level will not be displayed if [AREA MODE] is set to [FOCUS], [IRIS] or
[FOCUS/IRIS].
≥ Register “Push AF” to a USER button. (l 65)
You can use One Push AF and Push AF. (l 47)
≥ Register “Capture” to a USER button. (l 65)
You can record still pictures or create still pictures from recorded motion pictures. (l 40, 90)
≥ Register “EVF/LCD detail” to a USER button. (l 65)
[EVF/LCD DETAIL] helps you achieve focus easier by emphasizing the outlines of an image
displayed on the LCD monitor or the viewfinder. (l 46)
≥ These settings will not affect the images actually recorded.
≥ Register “LCD/EVF Output” to a USER button. (l 65)
This changes how to turn on/off the LCD monitor and Viewfinder. (l 30)
Push AF
Capture
EVF/LCD detail
LCD/EVF Output
R68S3_PJPB.book 73 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
