- 23 -
∫ Attaching the front microphone
≥ The microphone holder is set up so that a 21 mm (0.83 q) external microphone (AG-MC200G:
optional) can be attached. Check in advance whether the microphone you wish to use can be
attached.
1 Attach the microphone holder to the microphone holder attachment part.
≥ Attach by using a commercially available screw driver.
≥ When attaching the microphone holder, be sure to tighten the screws firmly even though you
might hear a squeaking sound.
2 Attach an external microphone
(optional) to the microphone holder,
and tighten the microphone holder
screw.
3 Connect the external microphone to
the AUDIO INPUT1 terminal (XLR 3
pin).
≥ When wiring the microphone cable, use the
cable clamper of this unit.
≥ Keep the microphone holder screw and
INPUT terminal cap out of reach of children
to prevent swallowing.
∫ Attaching the INPUT terminal cap
Attach the INPUT terminal cap while the AUDIO INPUT1, 2 terminals (XLR 3 pin) are not used.
A Microphone holder attachment part
B Microphone holder
C Microphone holder mounting screws
D AUDIO INPUT1 terminal (XLR 3 pin)
E Microphone cable clamper
F Microphone holder screw
G External microphone (optional)
R68S3_PJPB.book 23 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
