- 52 -
≥ To return to Auto White Balance Mode, press the WHITE BAL button or switch to Intelligent Auto
Mode using the iA/MANU switch.
≥ It is not possible to change the white balance mode in the following situations:
j When [SCENE MODE] is set to [Beach]/[Sunset]/[Fireworks] (l 112)
j During Freeze Frame (l 71)
You can set ATW Lock by registering [ATW LOCK] to a USER button.
≥ Please refer to page 65 for details about setting the USER button.
1 Set the White Balance mode to [ATW].
≥ Press the WHITE BAL button if a setting other than [ATW] is selected.
2 Press the USER button to which [ATW LOCK] is registered or touch the
applicable USER button icon.
≥ To cancel ATW Lock, press the USER button or touch the USER button icon again. Canceling
ATW Lock will return the White Balance mode back to [ATW].
≥ ATW Lock is not available except when the White Balance mode is set to [ATW].
≥ It will be canceled when the unit is turned off.
Setting the White Balance mode to [VAR] allows you to set a White Balance value between 2000K
and 15000K.
≥ Use the jog dial to change the settings.
≥ Switch to Manual Mode. (l 42)
1 Set the White Balance mode to [VAR]. (l 51)
2 Push the jog dial.
3 Rotate the jog dial to adjust the color balance.
4 Push the jog dial to
finish the adjustment.
To set ATW Lock
To finely adjust the White Balance
R68S3_PJPB.book 52 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
