- 54 -
Iris value:
CLOSE
!#
(F11 to F1.9)
!#
OPEN
≥ Value closer to CLOSE darken the image.
≥ Value closer to OPEN brighten the image.
≥ To return to Auto Iris Mode, press the IRIS button, or set this unit to Intelligent Auto Mode using
the iA/MANU switch.
≥ It is not possible to adjust the iris in the following situations:
j When a setting in [SCENE MODE] is enabled (l 112)
j During Freeze Frame (l 71)
≥ Depending on the zoom magnification, there are iris values that are not displayed.
≥ In Auto Gain Mode or Auto Shutter Mode, the screen brightness may not change even if you
adjust the iris. (l 55, 57)
∫ To enable Backlight Compensation
If you enable [BACKLIGHT COMPENS.] in Auto Iris Mode, automatic iris control will be activated for
backlight compensation, brightening the screen image by preventing subjects from appearing dark
when there is a light source behind them.
Select the menu. (l 36)
≥ appears when it is set.
≥ It will return to standard Auto Iris Mode ( ) when it is canceled. (l 53)
≥ You can also change the setting using the USER button to which [BACKLIGHT] is registered
(l 68)
This function is registered to the USER2 button by default.
≥ This function is not available in the following cases:
j When [SCENE MODE] is set to [Fireworks] (l 112 )
j During Freeze Frame (l 71)
j Backlight Compensation is canceled when you turn off this unit.
: [CAMERA SETUP] # [BACKLIGHT COMPENS.]# [ON]
MENU
R68S3_PJPB.book 54 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
