JOG Operation FP∑ Positionig Unit
8-4
8.1.2 JOG Operation (Forward, Reverse and Speed Changes)
This is the basic program for forward and reverse rotation using the external switch.
The direction in which the elapsed value increases as the motor rotates is set as the plus (+) direction
-Pulses are output as long as the startup flag is ON in the manual mode.
-There are two flags for start, one for forward rotation and one for reverse rotation.
-In the example shown below, the selector switch is used to switch between high-speed and low - speed
operation.
Pulse output diagram
To Next Page
Loading...
