57
VQT1H64
Recording
When recording, the input level from the built-in
microphones can be adjusted.
¬Rotate the mode dial to select .
1 Press the MENU button, then
select [VIDEO] # [MIC LEVEL] #
[SETrAGC] or [SET] and press
the cursor button.
AGC: Auto Gain Control
[AUTO]: AGC is activated, and the
recording level is adjusted
automatically.
[SETrAGC]: The desired recording level can
be set. AGC will also be
activated to reduce the amount
of sound distortion.
[SET]: AGC is not activated and so
natural recording can be
performed.
2 Move the cursor button left or
right to adjust the microphone
input level.
A Left
B Right
C Microphone input level
≥ A gain value for each of the 2 built-in
microphones is displayed. (The input level of
the microphones cannot be set individually.)
3 Press the cursor button to set
and then press the MENU button
to finish the setting.
D Microphone input level meter
≥ Microphone input level meter is displayed on
the screen.
To return to automatic setting
Press the MENU button, then select [VIDEO] #
[MIC LEVEL] # [AUTO], and press the cursor
button.
≥ Adjust the gain value so that the last 2 bars of
the microphone input level on the centre of the
screen will not light red. (Otherwise, the sound
is distorted.) Select a lower setting for gain
value or set [MIC LEVEL] to [AUTO].
≥ The microphone input level meter displays the
microphone input level for the built-in
microphone with the larger volume.
≥ When [ZOOM MIC] is [ON], the volume will be
different depending on the zoom rate. Set
[ZOOM MIC] to [OFF] or set the microphone
input level after adjusting the zoom rate.
(l 49)
Microphone level
This is for adjusting the microphone
input level.
A B
D
HDCSD5-VQT1H64_eng.book 57 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
