103
VQT1H64
With a computer
1 Double click the ( ) icon in
task tray displayed on the
computer.
Hardware disconnect dialogue appears.
≥ Depending on your computer’s settings, this
icon may not be displayed.
2 Select [USB Mass Storage
Device] and click [Stop].
3 Verify [MATSHITA HDC-SD5 USB
Device] is selected and click
[OK].
Click [Close], and you can safely disconnect the
cable.
≥ Do not disconnect the USB cable while the
card access lamp is lit ( appears on the
LCD monitor) as it may damage the data.
To verify this unit is correctly recognised by the
computer, connect the unit to the computer with a
USB cable, select [PC CONNECT] on the USB
function selection screen and then follow the
steps below.
≥ With some computers including those made by
NEC, the Device Manager may not be
displayed if a mode that places restrictions on
the functions has been established. Consult
the manufacturer or follow the steps in your
computer’s operating instructions to establish a
mode in which all the functions can be used,
then proceed with operation.
1 (When using Windows XP/2000)
Select [start] # ([Settings] #)
[Control Panel] # ([Performance
and Maintenance] #) [System].
(When using Windows Vista)
Select [start] # [Control Panel] #
[System and Maintenance] #
[Device Manager].
2 (When using Windows XP/2000)
Click the [Hardware] tab, then
click [Device Manager].
To disconnect USB cable
safely
Verifying the unit is correctly
recognised by the computer
HDCSD5-VQT1H64_eng.book 103 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
