54
VQT1H64
Recording
≥ When [FLASH AUTO] is set, the ambient
brightness is automatically detected, and the
flash will activate only when necessary. (If the
flash is not necessary, the [ßA] indicator will
not appear when the PHOTO SHOT button is
pressed halfway.)
≥ This function’s default setting is
[FLASH AUTO].
3 Press the PHOTO SHOT button.
The flash is activated and the picture will be
recorded.
When the flash is not used
Set the flash to [FLASH OFF].
≥ Do not block the flash with your hand or by
other means.
≥ The unit automatically determines if the flash is
necessary even when it has been set to
[FLASH OFF] by detecting the ambient
brightness. (If it determines that the flash is
necessary, the [ ] indication lights up in red
when the PHOTO SHOT button is pressed
halfway.)
≥ If the [ß] indication etc. flashes or is not
displayed when the PHOTO SHOT button is
pressed halfway, the flash is not activated.
≥ The available range of the flash is approx. 1 m
to 2.5 m in dark places. Pictures will appear
dark or reddish when they are recorded by
using the flash at distances greater than 2.5 m.
≥ Using the flash fixes a shutter speed of 1/750
or faster to 1/500.
≥ The picture may become out of focus in dark
places. If so, adjust the focus manually.
≥ The picture may appear dark if the flash is lit in
front of a white background.
≥ A conversion lens (optional) can block the flash
and may cause a vignetting effect.
≥ Do not use the flash with the ND filter (optional)
attached.
≥ Set the flash to [FLASH OFF] where using a
flash is prohibited.
≥ If the flash will be activated a large number of
times, it may take longer to charge it.
Reduces the phenomena where human eyes
become red from flashes.
Press the MENU button, then select
[PICTURE]
# [RED EYE] # [ON] and
press the cursor button.
To cancel the red eye reduction function
Press the MENU button, then select [PICTURE]
# [RED EYE] # [OFF] and press the cursor
button.
≥ The flash is activated 2 times. Do not move
until the second flash is finished.
≥ Use this when you take pictures of people in
dark places.
≥ Red eye phenomenon may appear depending
on the recording conditions.
Press the MENU button, then select
[PICTURE] > [FLASH LEVEL] #
desired item and press the cursor
button.
[ßj]: If the brightness is too high.
[ßd0]: In normal recording
[ßi]: If the brightness is insufficient.
Red eye reduction function
To adjust the brightness of the
flash
HDCSD5-VQT1H64_eng.book 54 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
