17
VQT1H64
Before using
Rotate the lens hood
counter-clockwise A to remove it. In
order to attach it, place into slot B,
and then rotate it clockwise C.
≥ Attach the MC protector or the ND filter of the
Filter Kit (VW-LF37WE; optional) in front of the
lens hood. Do not attach the other accessories
on the hood. (Except for the lens cap)
(Refer to the operating instructions for the
Filter Kit.)
≥ When fitting the tele conversion lens
(VW-T3714H; optional) or the wide conversion
lens (VW-W3707H; optional), first remove the
lens hood.
(Refer to the operating instructions for the tele
conversion lens or the wide conversion lens.)
(Be careful about the following.)
When 2 lens accessories, such as the ND filter
and tele conversion lens, are fitted and the W/T
lever is pressed toward the W side, the 4 corners
of an image will be darkened. (Vignetting)
(When fitting 2 lens accessories, first remove the
lens hood and then fit them.)
Attach the lens cap to protect the surface of the
lens.
≥ When the MC protector or the ND filter of the
Filter Kit (VW-LF37WE; optional) is attached to
the front of the lens hood, use the lens cap
included in the Filter Kit.
1 Pass the end of the lens cap cord
through the belt.
2 Pass the lens cap through the
loop.
3 To attach or remove the lens cap,
hold both sides of the lens cap
with the tips of your finger and
thumb.
Lens hood
A
C
B
Attaching the lens cap
(Included in the Filter Kit
(VW-LF37WE; optional))
HDCSD5-VQT1H64_eng.book 17 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
