61
VQT1H64
Recording
The centre of the screen is enlarged. The normal
screen returns approximately 2 seconds after
you finish bringing the subject into focus.
≥ The centre of the screen is not enlarged when
[MF ASSIST] is [OFF].
To restore to the automatic adjustment
Press the AUTO/MANUAL/FOCUS switch down
again to the FOCUS position.
≥ You can also restore the auto focusing by
setting the AUTO/MANUAL/FOCUS switch to
AUTO.
≥ The subject may not be in focus when zoomed
in if focusing with a wide angle. First, zoom in
on the subject, and then focus on it.
The centre of the screen is enlarged during
manual focus adjustment. This allows you to
focus on the subject more easily.
≥ MF assist does not work if the zoom
magnification is more than 10k.
≥ The part of the screen that is enlarged is not
enlarged on the image actually recorded.
≥ The zebra pattern does not appear on the part
of the screen that is enlarged when [ZEBRA] is
[ON].
The automatic white balance function may not
reproduce natural colours depending on the
scenes or lighting conditions. If so, you can
adjust the white balance manually.
¬Rotate the mode dial to select .
1 Set the AUTO/MANUAL/FOCUS
switch to MANUAL.
The icon shown in the illustration is displayed
automatically.
2 Move the cursor button up to
select [ ].
3 Move the cursor button left or
right to select the white balance
mode.
[ ]:Auto white balance adjustment
[ ]: Indoor mode (for recording under
incandescent lamps)
≥ Incandescent lights, halogen lamps
[ ]: Outdoor mode
≥ Outdoors under a clear sky
[ ]: Manual adjustment mode
≥ Mercury-vapor lamps, sodium lamps,
some fluorescent lights
About the MF assist function
White balance
This is for recording in natural
colours.
AWB
HDCSD5-VQT1H64_eng.book 61 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
