29
VQT1H64
Setup
Quick start
When quick start is ON the battery power is still
being consumed, even when the LCD monitor is
closed.
This unit will resume recording/pause mode
about 1.7 seconds after the LCD monitor is
reopened.
≥ When in quick start standby mode about
70% of the power used in recording pause
mode is being consumed, so the recording
time will be reduced.
¬Rotate the mode dial to select and
insert an SD card in this unit.
1 Press the MENU button, then
select [SETUP] #
[QUICK START] # [ON] and
press the cursor button.
2 Close the LCD monitor while the
mode dial is set to .
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is
put into recording pause approx. 1.7 seconds
after it is turned on.
ª To cancel Quick start
Press the MENU button, then select [SETUP]
# [QUICK START] # [OFF] and press the
cursor button.
≥ The status indicator goes off, the lens cover
closes and the power turns off if the mode dial
is set to OFF while the unit is in quick start
standby mode.
≥ The status indicator goes off and the power
turns off if quick start standby mode continues
for approx. 5 minutes.
≥ Quick start standby mode is cancelled, the
status indicator goes off and the power turns
off in the following cases.
jthe mode dial is switched
jthe battery is removed or the AC adaptor is
disconnected
≥ When this unit is quick-started with the white
balance on automatic, it may take some time
until the white balance is adjusted if the scene
being recorded has a light source different
from the scene last recorded. (When the colour
night view function is used, however, the white
balance of the scene last recorded is retained.)
≥ When this unit is quick-started, the zoom
magnification becomes 1k and the picture size
may differ from what it was before quick start
standby mode.
≥ If [POWER SAVE] (l 111) is set to
[5 MINUTES] and the unit automatically goes
into quick start standby mode, close the LCD
monitor and then open it again.
A
HDCSD5-VQT1H64_eng.book 29 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
