EasyManua.ls Logo

Panasonic HDC-SD5 - Advanced and Setup Menu Settings; Advanced Menu Settings Explained

Panasonic HDC-SD5
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
111
VQT1H64
Others
ª [REC LAMP]
The recording lamp lights during recording and
flashes when the unit receives a signal from the
remote control or when the self-timer is counting
down. When this is set to [OFF], it does not light
during recording.
ª [DISPLAY]
The screen indications are selected as shown in
the illustration below.
[OFF]
[ON]
ª [POWER SAVE]
[OFF]:
The power saving function is not activated.
[5 MINUTES]:
When about 5 minutes have passed without any
operation, this unit automatically turns off to
prevent the battery from running down. When
you use this unit, turn it on again.
In the following cases, the unit may not turn off
even when you set this to [5 MINUTES].
jWhen using the AC adaptor
jWhen the unit is connected to a computer,
printer or DVD burner with the USB cable.
jWhen PRE-REC is used
ª [BEEP SOUND]
This allows operations such as starting and
ending recording to be signaled by a beep.
When [OFF] is set, no beep is heard when an
operation such as recording is started or ended.
1 Beep
When you start recording
When you turn on the power
When this unit is recognised by the computer or
the printer etc.
2 Beeps
When you pause recording
When you turn off the power
2 Beeps/4 times
When an error occurs e.g. recording not starting.
Check the sentence displayed on the screen.
(l 114)
ª [INITIAL SET]
When there is a menu that cannot be selected
due another function or mode being activated,
set to [YES] for changing the menu settings back
to the initial shipping condition.
(The language setting cannot be changed back
to the initial shipping condition.)
ª [DEMO MODE]
This item is used to start the unit demonstration.
(Only when the mode dial is at the position)
If you set [DEMO MODE] to [ON] without
inserting an SD card, the demonstration
automatically starts. If any operation takes place,
the demonstration is cancelled. However if no
operations take place for approx. 10 minutes, the
demonstration automatically starts again. To stop
the demonstration, set [DEMO MODE] to [OFF]
or insert an SD card. For normal use, set
[DEMO MODE] to [OFF].
Menus related to [ADVANCED]
[OFF] [ON]
Menus related to [SETUP]
[OFF] [ON]
[OFF] [5 MINUTES]
15.12.2006
R30min
60min
0h00m00s
AUTO
1
+
1920
[OFF] [ON]
[YES] [NO]
[OFF] [ON]
HDCSD5-VQT1H64_eng.book 111 ージ 007年8月1日 水曜日 午後7時16分

Table of Contents

Other manuals for Panasonic HDC-SD5

Related product manuals