101
VQT1H64
With a computer
Connection and recognition
After the software applications are installed, this
unit must be connected to the computer and be
correctly recognised by the computer.
≥ Connect after installing the software
applications.
≥ Remove the supplied CD-ROM if it is inserted
in the computer. (If the [Setup Menu] screen is
displayed, wait until it finishes and then remove
the CD-ROM.)
≥ If the recognition procedure is not
accomplished properly, operation will not be
possible after connecting the unit to the
computer.
≥ If the unit fails to operate normally, it may mean
that you have not conducted the installation or
recognition procedure properly.
1 Connect this unit to the AC
adaptor.
≥ If a battery is used, operation is not possible
when this unit is connected to a computer.
2 Insert an SD card with recorded
images in this unit, then turn on
the unit.
3 Connect this unit and a
computer.
A USB cable (supplied)
The USB function selection screen will appear.
≥ Insert the plugs as far as they will go. The unit
and computer will not operate properly if the
plugs are not inserted fully.
≥ Do not use any other USB connection cables
except the supplied one. (Operation is not
guaranteed with any other USB cables.)
4 Select [PC CONNECT] and press
the cursor button.
This unit is automatically recognised by the
computer.
≥ When the unit is connected to a computer,
the operation mode cannot be changed and
its power cannot be turned off.
In this case, disconnect the USB cable
(l 103).
≥ When a computer is accessing the SD card in
this unit, the card access lamp lights up. (When
a card is being accessed, appears on the
LCD monitor.) Do not disconnect the USB
cable or AC adaptor while the card is being
accessed as it may damage the data.
≥ It may be necessary to reboot the computer
after connecting this unit to it for the first time.
Connection and recognition
procedures
A
HDCSD5-VQT1H64_eng.book 101 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
