71
VQT1H64
Editing
4 (Only when [SELECT] is selected in step 2)
Press the button.
5 When the confirmation message
appears, select [YES], then press
the cursor button.
(Only when [SELECT] is selected in step 2)
To continue deleting other scenes
Repeat steps 3-5.
To complete editing
Press the MENU button.
≥ You can also delete scenes by pressing the
MENU button, selecting [EDIT SCENE] #
[DELETE] and then selecting [ALL SCENES]
or [SELECT].
≥ To delete an unwanted part of a scene, divide
the scene first, and then delete the
unnecessary part.
≥ Scenes which cannot be played back (the
thumbnails are displayed as ) cannot be
deleted.
≥ Protected scenes cannot be deleted.
≥ Do not open the SD card/battery cover while
deleting. The deletion will stop.
≥ In case of [ALL SCENES], the deletion may
take time if there are many scenes on the SD
card.
≥ Do not turn off this unit while deleting.
≥ When you delete scenes, use a battery with
sufficient battery power or use the AC adaptor.
≥ If you delete scenes recorded on other
products with this unit, all the data related to
the scenes may be deleted.
To delete an unnecessary portion of a scene, first
divide the scene and then delete the
unnecessary portion.
¬Rotate the mode dial to select
and then select the [ ] (motion
picture playback) tab.
1 Press the MENU button, then
select [EDIT SCENE] # [DIVIDE]
# [SET] and press the cursor
button.
2 Select the scene to be divided,
then press the cursor button.
The selected scene is played back.
3 When you reach the area where
you want to divide the scene,
press the cursor button down to
set the dividing point.
≥ Using slow-motion playback or frame-by-frame
playback makes it easy to search for the point
where you want to divide the scene. (l 65, 66)
4 When the confirmation message
appears, select [YES], then press
the cursor button.
Dividing a scene to delete
This is for dividing a scene into two to
delete an unnecessary portion.
HDCSD5-VQT1H64_eng.book 71 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
