24
VQT1H64
Setup
Inserting/removing the battery
1 While sliding the SD CARD/
BATTERY OPEN lever A, move
the SD card/battery cover to open
it.
2 Insert the battery until it clicks
paying attention to the direction
of the battery.
B Push the centre of the battery until it locks.
3 Close the SD card/battery cover.
≥ Securely close it until it clicks.
1 Open the SD card/battery cover.
2 Remove the battery.
≥ Move A in the direction of the arrow to unlock
it and then remove the battery.
3 Close the SD card/battery cover.
≥ Be sure to set the mode dial to OFF and check
that the status indicator is off before removing
the battery.
≥ The SD card/battery cover opens up to 180o.
Notice about the rechargeable battery
The battery is designated recyclable.
Please follow your local recycling regulations.
Inserting the battery
A
1
2
Removing the battery
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
Warning
Risk of fire, explosion and burns. Do not
disassemble, heat above 60 xC or incinerate.
A
HDCSD5-VQT1H64_eng.book 24 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
