55
VQT1H64
Recording
By focusing only on the subject and blurring the
background, the image can be impressive.
The unit can focus on the subject at a distance of
approx. 50 cm.
¬Rotate the mode dial to select .
1 Press the cursor button. Then
move the cursor button down to
display the icon shown in the
illustration.
2 Move the cursor button right to
select [ ].
≥ If the magnification is 10k or less, then it is
automatically set to 10k.
To cancel the tele macro function
Select [ ] again.
≥ If a sharper focus cannot be achieved, adjust
the focus manually. (l 60)
≥ In the following cases, the tele macro function
is cancelled.
jThe zoom magnification becomes lower than
10k.
jThe power is turned off or the mode dial is
operated.
Reduces the image shaking (jitter) due to hand
movement when recording.
¬Rotate the mode dial to select .
Press the MENU button, then select
[BASIC] # [O.I.S.] # [ON] and press
the cursor button.
To cancel the image stabilizer function
Press the MENU button, then select [BASIC] #
[O.I.S.] # [OFF] and press the cursor button.
≥ This function’s default setting is [ON].
≥ In still picture recording mode, pressing the
PHOTO SHOT button halfway increases the
effect of the image stabilizer function. (MEGA
optical image stabilizer)
≥ When a tripod is used, we recommend that you
turn the image stabilizer off.
≥ In the following cases, the image stabilizer
function may not work effectively.
jWhen the digital zoom is used
jWhen the unit is shaken greatly
jWhen you record a moving subject while
tracking it
jWhen the conversion lens is used
Tele macro function
This is for bringing only what you
want to record into focus to take
close-ups.
Image stabilizer function
This is for reducing image shakes
during recording.
HDCSD5-VQT1H64_eng.book 55 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
