72
VQT1H64
Editing
5 Delete the unnecessary scene.
Refer to page 70 for how to delete scenes.
To continue dividing other scenes
Repeat steps 2-4.
To complete editing
Press the MENU button.
To delete all the divided points
Press the MENU button, then select
[EDIT SCENE] # [DIVIDE] # [CANCEL ALL]
and press the cursor button.
≥ When the confirmation message appears,
select [YES], then press the cursor button.
≥ All divided points set on this unit will be
cancelled.
≥ The scenes that were deleted after division
cannot be recovered.
≥ Scenes cannot be divided if the number of
scenes has reached 999.
≥ It may not be possible to divide scenes with a
short recording time.
≥ If images that have been divided are played
back on another device, the points where the
scenes join may not be clear.
≥ Data that has been recorded or edited on
another device cannot be divided and the
divided points cannot be deleted.
≥ When [CANCEL ALL] is selected, the divided
points of all scenes are deleted and the unit
turns back to the setting that plays back all
scenes even if you selected to play back the
scenes by date.
Scenes can be protected so that they are not
deleted by mistake.
(Even if you protect some scenes on an SD
card, formatting the SD card will delete them.)
¬Rotate the mode dial to select
and then select the [ ] (motion
picture playback) tab.
1 Press the MENU button, then
select [PLAY SETUP] #
[SCENE PROTECT] # [YES] and
press the cursor button.
2 Select the scene to be protected
and then press the cursor button.
The [ ] indication appears and the scene is
protected.
≥ Press the cursor button again to cancel the
setting.
≥ 2 or more scenes can be set in succession.
To complete the settings
Press the MENU button.
Protecting scenes
This is for preventing scenes from
being deleted by mistake.
HDCSD5-VQT1H64_eng.book 72 ページ ２００７年８月１日 水曜日 午後７時１６分
To Next Page
Loading...
