6.6.6.1. JOURNAL 2
Refer to JOURNAL 2 in PRINTOUT EXAMPLE().
Journal 2 displays the additional detailed information about the last 35 communications.
Descriptions:
(1) RCV. MODE
Indicates which receive mode the unit was in when the unit received a fax message.
This information is also displayed when the unit transmitted a fax message.
(2) SPEED
Indicates the speed of the communication. If multiple pages are transmitted or received, it
indicates the last page’s communication speed. If there is a communication error, "?" is
displayed.
(3) RESOLUTION
Indicates the resolution of the communication. If multiple pages are transmitted or received, it
indicates the last page’s resolution. If there is a communication error, "?" is displayed.
(4) RCV-TRIG. (CNT.)
Indicates the trigger that causes the unit to switch to the fax receive mode. The available options
are listed in JOURNAL 2 in PRINTOUT EXAMPLE(). The values in parenthesesindicate how many
times the trigger has been used. (For example, "0003" means three times.)
No. Display Function
1 FAX MODE Means the unit received a fax message in the FAX mode.
2 MAN RCV Means the unit received a fax message by manual operation.
3 FRN RCV Means the unit received a fax message by friendly signal detection.
4 VOX Means the unit detected silence or no voice.
5 RMT DTMF Means the unit detected DTMF (Remote Fax activation code) entered
remotely.
6 PAL DTMF Means the unit detected DTMF (Remote Fax activation code) entered by a
parallel connected telephone.
7 TURN-ON Means the unit started to receive after 10 rings. (Remote Turn On: Service
Code #573)
8 TIME OUT Means the unit started to receive after Ring Time Out in the EXT-TAM or TEL
/FAX mode.
9 IDENT Means the unit detected Ring Detection.
10 CNG OGM
Means the unit detected the CNG while it was sending the Dummy Ring
Back Tone in the TEL/FAX mode.
OR
Means the unit detected the CNG while it was sending the OGM in the ANS/
FAXmode.
11 CNG ICM Means the unit detected the CNG while it was recording the ICM in the ANS/
FAX mode.
(5) ERROR MEMORY
Indicates the reason why the unit received a fax message in memory.
If you look at No.11 in the JOURNAL 2 in PRINTOUT EXAMPLE(), it shows the fax message was
received in memory due to "PAPER OUT" error.
[NO RESPONSE DISAPPEARED ON JOURNAL]
The "NO RESPONSE DISAPPEARED ON JOURNAL" displays the information about the last 10
123
To Next Page
Loading...
