3-8 Telephone Features
A 3.2 Telephone Features
Conditions
• In the Verify-All mode, you must always enter a pre-assigned account code when
making any of the following calls unless one has previously been stored in memory.
a) Call Forwarding — to an Outside (CO) Line
b) Manual Dialing (Selecting an outside (CO) line)
c) One-Touch Dialing (PT only)
d) Pickup Dialing (Hot Line) (SLT only)
e) Personal Speed Dialing
f) System Speed Dialing
• In the Verify-Toll mode, you can enter a pre-assigned account code only when you
need to override toll restriction.
• In the Option mode, you can record a calling or called party’s account code in the
SMDR during a conversation or within thirty seconds after the other party hangs up.
• You do not need to make an account code entry when receiving incoming calls.
• You can clear and re-enter a number by pressing “” or the FWD/DND button while
entering an account code.
• An account code can be stored into Memory Dialing (“One-Touch Dialing”, “Pickup
Dialing (Hot Line)”, “System/Personal Speed Dialing”, “Call Forwarding — to Outside
(CO) Line”). To store an account code, “”must be entered before the account code.
Example (Pickup Dialing):
— [Off-hook] [742] [Line Access Code] [ ] [Account Code] [Phone Number] [#]
[On-hook]
• If an entered account code does not match the pre-assigned account code in the
verify-all mode, when making an outside call, a reorder tone is heard.
• An account code has four digits (0 through 9). FLASH/RECALL, PAUSE, etc., cannot
be used.
Programming References
• System Programming — Installation Manual
[310] Account Codes
[601]–[603] TRS – Class of Service (COS) Assignment — Day/Night/Lunch
[605] Account Code Entry Mode
[805] SMDR Account Code Selection
Feature References
Station Message Detail Recording (SMDR) (→ See the Installation Manual.)
Toll Restriction Override by Account Codes
PT
To Next Page
Loading...
