2.7 Help
PC Programming Manual 105
A • Perform the following steps:
1. On the 2.10.14 [3-5-1] Incoming Call Distribution Group—Member List screen,
from the Incoming Call Distribution drop-down list, select the group you want to
modify.
The ICD group must have an extension number set.
2. Enter the extension number of the extension you want to add in a blank cell of the
Extension Number column.
3. Set Delayed Ring as necessary.
4. Click Apply.
Note that it is necessary to set the extension number of the ICD group in advance.
Q
I cannot set system speed dialling numbers from PC Console.
A • Set the COS of the extension to which PC Console is connected to Manager class, by
setting Manager on the Extension Feature tab of the 2.9.11 [2-7-1] Class of Service—
COS Settings screen to "Enable".
• System speed dialling numbers can only be edited by one PC Console at a time.
Q
I have set FWD through system programming, but calls are still not being
forwarded.
A • Perform the following steps:
1. Check that the Call from CO—Present Button Status or Call from Extension—
Present Button Status of the target extension on the 2.11.3 [4-1-2] Wired
Extension—FWD/DND or 2.11.12 [4-2-2] Portable Station—FWD / DND screen is
set to "FWD".
2. Create a FWD button on the target extension if one does not already exist.
3. Press the FWD button so that it changes to FWD status.
To Next Page
Loading...
