Panasonic KX-TDA100

2.1 Introduction
PC Programming Manual 27
2.1.2 Access Levels
There are three main levels of access to the Maintenance Console: User, Administrator and Installer.
Each level has its own Programmer Code, which must be entered to run the Maintenance Console.
The allowed format for each programmer code is as follows:
Access to menu options within the Maintenance Console is restricted depending on the Programmer
Code, and the current software mode (see 2.1.1 Starting Maintenance Console and Software
Modes). When a menu option is limited to certain access levels, this is noted in this manual in the
initial description of that menu option, for example:
"This option is only available at Installer level."
If a sentence like this does not appear under the heading, the menu option is available at all levels.
The target users for each access level are as follows:
The options available in each mode and access level are shown below.
The access levels are abbreviated as follows:
U: User; A: Administrator; I: Installer
A check mark indicates that the menu option is available for that access level.
Item Length
User Level Programmer Code 0 – 16 characters
Administrator Level Programmer Code 4 – 16 characters
Installer Level Programmer Code 4 – 16 characters
Access Level User
User For end users
Administrator For system administrators
Installer For dealers and system installers
Start Menu
Menu Option Batch Interactive
UA I UA I
New
Open
Connect—RS-232C
Connect—USB
Connect—LAN
Connect—Modem
Connect—ISDN Remote