Panasonic KX-TDA100

2.6 Utility
84 PC Programming Manual
2.6.11 Utility—ISDN/QSIG Protocol Trace
This utility collects protocol trace data from BRI, PRI or IP-GW cards, and displays it on the PC.
This option is only available at Installer level, and requires that the target BRI, PRI or IP-GW card be
set to INS status.
Protocol trace data is continually accumulated on ISDN and IP-GW cards, and 3 types of data can be
downloaded:
• Real Time Trace (not available when connected via LAN): Pseudo-real-time data is collected
through data polling at one-second intervals. The displayed information is updated beginning
when the Start button is clicked.
• Accumulation Trace: Previously accumulated data is retrieved and displayed.
• Error Accumulation Trace: Previously accumulated error data is retrieved and displayed. This
trace shows the data snapshot that is taken just before a card resets.
To view trace data
1.
From the Utility menu, select ISDN/QSIG Protocol Trace.
2. From the Slot No drop-down list, select the target slot.
3. From the Trace Data Type drop-down list, select the type of data to view.
4. Click Start.
Trace information will be displayed.
5. Select an option:
•Click Capture to save the displayed trace information.
•Click Clear to clear the screen display.
6. Click Cancel to return to the main screen.