Panasonic KX-TDA100 Pc Programming Manual

2.8 [1] Configuration
PC Programming Manual 289
2.8.30 [1-1] Slot—Card Property - DID type
The property for the DID card can be specified.
First Dial Timer
Specifies the minimum time that the PBX waits after seizing a DID line, before sending the dialled
digits to the telephone company or to another PBX. This allows the telephone company or the other
PBX to have enough time to accept the dialled digits correctly.
Value Range
32 × n (n=1–255) ms
Maintenance Console Location
2.8.30 [1-1] Slot—Card Property - DID type
Programming Manual References
None
Feature Guide References
None
DTMF Tone—DTMF Inter-digit Pause
Specifies the length of the DTMF inter-digit pause. This allows the telephone company to have
enough time to accept the dialled digits correctly.
Value Range
64 + 16 × n (n=0–11) ms
Maintenance Console Location
2.8.30 [1-1] Slot—Card Property - DID type
Programming Manual References
None
Feature Guide References
None
Pulse Dial—Pulse % Break
Specifies the % break for pulse digits. This is the ratio between the break (on-hook) signal and make
(off-hook) signal in a pulse dial.
Value Range
60 %, 67 %

Panasonic KX-TDA100 Specifications

General

System Capacity	Up to 128 extensions
VoIP Support	Yes, with optional cards
Digital Extensions	Yes
Analog Extensions	Yes
ISDN Support	Yes
Power Supply	AC 100-240 V, 50/60 Hz
Operating Temperature	0°C to 40°C
Humidity	10% to 90% (non-condensing)
Networking	Yes
Type	Hybrid IP PBX
Wireless Capability	Yes
Supported Extensions	Digital, Analog
Trunk Interfaces	Analog, ISDN
Voicemail Capacity	Optional, via voice processing cards