Panasonic KX-TDA100

2.8 [1] Configuration
PC Programming Manual 337
2.8.47 [1-2] Portable Station
Various portable station (PS) settings can be programmed. A maximum of 28 (with the KX-TDA30),
128 (with the KX-TDA100/KX-TDA200), 256 (with the KX-TDA600) or 512 (with the KX-TDA600 with
EMEC card installed) PSs can be registered.
Information on 32 PSs is displayed at a time. To display other PSs, click the applicable tab.
PS Registration and De-registration
A PS must be registered to the PBX by programming both the PBX and PS before it can be used.
Programming instructions of the PBX are given below; programming instructions of the PS are found
in the Installation Manual.
It is possible to de-register the PS later.
Registration
Follow the steps below to register the PS.
1. Click Registration.
A dialogue box will appear. Non-registered (available) extension numbers are displayed on
the left.
2. Highlight numbers and click the right arrow to select them for registration. Click Next.
A screen will appear with information on the current PS extension number and index number
for programming.
3. Register the relevant PS.
For details, refer to the Installation Manual.
KX-TDA30:
Registering DECT PS → 2.7.7 Connecting a Cell Station to the Hybrid IP-PBX
Registering 2.4 GHz PS → 2.8.7 Connecting a Cell Station to the Hybrid IP-PBX
KX-TDA100/KX-TDA200:
Registering DECT PS → 2.8.7 Connecting a Cell Station to the Hybrid IP-PBX
Registering 2.4 GHz PS → 2.9.7 Connecting a Cell Station to the Hybrid IP-PBX
KX-TDA600:
Registering DECT PS → 2.10.7 Connecting a Cell Station to the PBX
Registering 2.4 GHz PS → 2.11.7 Connecting a Cell Station to the PBX
4. Click Next.
• If the PS registration is still in progress, the dialogue box will show "Waiting for portable
station to register...". Click OK.
• If the registration is successful, the dialogue box will show "Registration Succeed".
If there are more PSs to be registered, click Continue to resume. If not, click Close.
Once a PS is successfully registered, the status of the PS will update to show "Registered".
De-registration
Follow the steps below to de-register the PS.
1. Click De-registration.
A dialogue box will appear. Registered extension numbers are displayed on the left.
2. Highlight numbers and click the right arrow to select them for de-registration. Click Next.
A dialogue box will appear.
3. Click Confirm.