Panasonic KX-TDA100

2.8 [1] Configuration
PC Programming Manual 107
3. Click Yes to confirm.
The card will be removed.
To change the status (INS/OUS) of a card (Interactive mode only)
1. Move the mouse pointer over the card.
A menu will be shown under the mouse pointer.
2. Select the desired status:
•Click INS to set the card to in-service status.
•Click OUS to set the card to out-of-service status.
To install an option card on an OPB3 card
1. Move the mouse pointer over the card.
A menu will be shown under the mouse pointer.
2. Select Option Card.
The OPB3 Option Card Setup screen will be displayed. See 2.8.43 [1-1] Slot—OPB3 Option
Card Setup (KX-TDA100/KX-TDA200/KX-TDA600 only).
Supported Card Types
KX-TDA30
Card Maximum
Quantity
Supported Slot
Numbers
Card Programming
MPR: Main Processing Card 1 00 2.8.3 [1-1] Slot—Card Property - MPR
DHLC4: Pre-installed Super Hybrid
Ports
101
2.8.4 [1-1] Slot—Card Property -
Extension Type
DLC4: 4-Port Digital Extension Card
1
02–04 (Type A
Slots)
SLC4: 4-Port Single Line Telephone
Extension Card
BRI1: 1-Port BRI Card
3
2.8.13 [1-1] Slot—Card Property - BRI
type/PRI type
BRI2: 2-Port BRI Card
LCOT2: 2-Port Analogue Trunk Card
2.8.10 [1-1] Slot—Card Property - LCO
type
LCOT4: 4-Port Analogue Trunk Card
DID3: 3-Port DID Card 2.8.30 [1-1] Slot—Card Property - DID
type