Panasonic KX-TDA100

2.8 [1] Configuration
PC Programming Manual 137
Maintenance Console Location
2.8.10 [1-1] Slot—Card Property - LCO type
Programming Manual References
None
Feature Guide References
None
Bell Detection—Bell Start Detection Timer
Specifies the minimum length of a bell signal that can be recognised by the PBX as the bell signal
sent from the telephone company, before the PBX detects an arriving call.
Value Range
24 × n (n=1–50) ms
Maintenance Console Location
2.8.10 [1-1] Slot—Card Property - LCO type
Programming Manual References
None
Feature Guide References
None
Bell Detection—Bell Off Detection Timer
Specifies the duration of the bell off detection timer. If the PBX receives no bell signal from the
telephone company for the length of time specified here, the PBX treats the call as lost.
Value Range
1.0 s–15.0 s
Maintenance Console Location
2.8.10 [1-1] Slot—Card Property - LCO type
Programming Manual References
None
Feature Guide References
None
Pulse / DTMF Dial—DTMF Inter-digit Pause
Specifies the length of the DTMF inter-digit pause. This allows the telephone company to have
enough time to accept the dialled digits correctly.