Panasonic KX-TDA100

1.2 PC Programming
PC Programming Manual 19
4.
a. Enter the Installer Level Programmer Code (default:
INSTALLER).
The Programmer Code authorises different
programming levels, and the Quick Setup is only
available when you start the Maintenance Console
with the Installer Level Programmer Code.
Note
There are 2 other Programmer Codes with limited
authorisation: Administrator Level (default: ADMIN),
and User Level (default: USER). (→ 1.2.2 Password
Security)
b. Click OK.
5. Click Connect.
6.
a. Select the USB tab.
b. Enter the system password for installer (default:
1234).
c. Click Connect.
Note
To connect to the PBX via USB, the KX-TDA USB
driver must be installed on the PC, as explained above
in "Installing the Maintenance Console".
7. When country/area data do not match:
a. Click OK to replace the country/area data of the PBX.
Replacement may take several minutes to complete.
b. Follow the procedure described in Section 2.16.1
Starting the PBX (for KX-TDA600), Section 2.13.1
Starting the Hybrid IP-PBX (for KX-TDA100/KX-
TDA200) or 2.12.1 Starting the Hybrid IP-PBX (for KX-
TDA30) in the Installation Manual and restart the PBX.
c. Click "Connect" → "USB" from the menu bar.
d. Repeat step 4 to restart the Maintenance Console.
8. Follow the instructions of the Quick Setup wizard and
assign the basic items.