Panasonic KX-TDA100

2.8 [1] Configuration
PC Programming Manual 229
Value Range
80 ms, 160 ms
Maintenance Console Location
2.8.19 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Guide References
None
CO Pulse Speed
Selects the speed at which pulse dials are sent to the T1 channel.
Value Range
10 pulse/s, 20 pulse/s
Maintenance Console Location
2.8.19 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Guide References
1.5.4.4 Dial Type Selection
Wink Signal Time Out
Specifies the length of time that the PBX waits to receive a wink signal after seizing a trunk. If a wink
signal is not received before this timer expires, the trunk is released.
Value Range
64 × n (n=1–128) ms
Maintenance Console Location
2.8.19 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Guide References
None
Start Signal Type
Selects the type of the start signal.