Panasonic KX-TDA100

2.1 Introduction
PC Programming Manual 25
Connection Settings for RS-232C
Setting Values Explanation
Port COMx Specify the number of the COM port assigned
to the PC's RS-232C interface. Only available
COM ports are displayed.
Baud Rate (bps) 2400, 4800, 9600,
19200, 38400, 57600,
115200
Specify the speed of data transmission.
Connection Settings for Modem
Setting Values Explanation
Dial Number 1-9, 0, *, #, -, ","
[comma], T, P, W
Enter the telephone number to be dialled to
access the PBX.
T: Converts the Dial Type from Pulse to Tone.
"," [comma], P, W: Inserts a pause.
Dial Type Auto(Tone),
Auto(Pulse), Manual
Specify the outgoing dialling method.
If Manual is chosen, dialling must be done with
a connected telephone.
Comment Max. 40 characters Enter a comment to identify the set of values.
Port COMx Specify the number of the COM port assigned
to the PC's modem interface.
Only available COM ports will be displayed.
Baud Rate (bps) 1200, 2400, 4800, 9600,
19200, 38400
Specify the speed of data transmission.
Modem Initialise – Enter the modem initialise command, and click
Initialise to send the command to the modem.
For more details, refer to your modem's
instruction manual.
Connection Settings for LAN
Setting Values Explanation
IP Address 1.0.0.0–
223.255.255.255
Specify the IP address of the PBX on the LAN.
Enter the same IP address that was input in IP
Address of 2.8.44 [1-1] Slot—Card Property
- CTILINK (KX-TDA100/KX-TDA200/KX-
TDA600 only).
Port Number 1–65535 Specify the port number used to access the
PBX via LAN. Enter the same port number that
was input in Maintenance Port Number of
2.8.44 [1-1] Slot—Card Property - CTILINK
(KX-TDA100/KX-TDA200/KX-TDA600 only)
or 2.8.33 [1-1] Slot—Card Property - IP
Gateway (KX-TDA30 only).