Panasonic KX-TDA100

2.8 [1] Configuration
PC Programming Manual 295
Programming Manual References
None
Feature Guide References
None
Connection
Indicates the port status (reference only).
This column offers two ways to open the screen to select the port command:
• Click the desired cell in the column.
• Select the desired cell in the column, and then click Command.
Value Range
INS: The port is in service.
OUS: The port is out of service.
Fault: The port is not communicating with the network.
Maintenance Console Location
2.8.31 [1-1] Slot—Port Property - DID Port
Programming Manual References
2.8.32 [1-1] Slot—Port Property - DID Port—Connection Command
Feature Guide References
None
Dialling Mode
Selects the type of signal used to dial out to the DID line.
Value Range
DTMF, Pulse
Maintenance Console Location
2.8.31 [1-1] Slot—Port Property - DID Port
Programming Manual References
None
Feature Guide References
1.5.4.4 Dial Type Selection
DTMF Width
Selects the length of the DTMF tone sent to the DID line.