Panasonic KX-TDA100

2.9 [2] System
PC Programming Manual 365
Maintenance Console Location
2.9.4 [2-3] Timers & Counters
Programming Manual References
None
Feature Guide References
1.17.9 External Sensor
Incoming Call Inter-digit Timer—DDI / DID
Specifies the length of time between digits when receiving a DDI/DID number from a public network.
The call will be redirected to a PBX operator when this timer expires.
Value Range
0–30 s
Maintenance Console Location
2.9.4 [2-3] Timers & Counters
Programming Manual References
2.17.3 [10-3] DDI / DID Table
Feature Guide References
1.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
Incoming Call Inter-digit Timer—TIE
Specifies the length of time between digits when receiving a dialled number from a TIE line. The call
will be redirected to a PBX operator when this timer expires.
Value Range
3–30 s
Maintenance Console Location
2.9.4 [2-3] Timers & Counters
Programming Manual References
2.16.1 [9-1] TIE Table
Feature Guide References
1.30.1 TIE Line Service
PT Display—PT Last Display Duration in Idle Mode
Specifies the length of time that the current information remains on the display after the extension
returns to idle status.