When loosening/tightening the screw, do not scratch the cabinet wall with the driver shaft.
2. Pass the wires through the hole in the base cover, and attach the base cover to a wall using 2 screws.
Screw
To 8-pin terminal block
Note
Two
kinds of screws are included with the doorphone. Please choose the appropriate kind for your wall
type.
: when a doorphone plate has been fixed to the wall
: when you wish to install the doorphone directly onto the wall
3. Connect the wires to the screws located in the back cover.
4. Re-attach the 2 halves and re-insert the screw.
Installation Manual 121
2.8.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
To Next Page
Loading...
