Panasonic KX-TDA100D

4.1.4 Using the Reset Button
If the PBX does not operate properly, use the Reset Button. Before using the Reset Button, try the system
feature again to confirm whether there definitely is a problem or not.
CAUTION
In order to avoid possible corruption of data on the SD Memory Card, please ensure that the
"SD
ACCESS" LED is off before pressing the Reset Button.
Note
• When
the System Initialise Switch is set to "NORMAL", pressing the Reset Button causes the following:
– Camp-on is cleared.
– Calls on hold are terminated.
– Calls on exclusive hold are terminated.
– Calls in progress are terminated.
– Call park is cleared.
Other data stored in memory, except the above, are not cleared.
• Be aware that pressing the Reset Button with the System Initialise Switch in the "INIT" position clears
all data stored in the PBX. Do not perform this operation unless you intend to delete all data from the
PBX.
Operation
If the PBX does not operate properly:
1. Slide the System Initialise Switch to the "NORMAL" position.
2. Press the Reset Button for about 1 second.
BATT
ALARM
SD
ACCESS
RESET
INIT
NORMAL
System Initialise Switch
Reset Button
RUN Indicator
LED
148 Installation Manual
4.1.4 Using the Reset Button