Panasonic KX-TDA100D

2.7.3 First Party Call Control CTI Connection
CTI
connection between a PC and a KX-DT343/KX-DT346/KX-T7633/KX-T7636 DPT provides first party call
control. The CTI connection is made via a USB interface (version 2.0), and uses the TAPI 2.1 protocol.
A USB Module must be connected to the DPTs.
Note
The operating system of the PC required for first party call control depends on your CTI application
software. For details, refer to the manual for your CTI application software.
KX-DT343/KX-DT346
USB Port
USB Cable
USB Module
To PC
KX-T7633/KX-T7636
USB Cable
To PC
ULL
USB Port
USB Module
Note
The maximum length of the USB cable is 3 m.
Installation Manual 119
2.7.3 First Party Call Control CTI Connection