2.2.6 Installing/Removing the Optional Service Cards
CAUTION
• To
protect the back board from static electricity, do not touch parts on the back board in the main unit
and on the optional service cards. To discharge static electricity, touch ground or wear an earthing
strap.
• When installing or removing the DMPR card, the DC power supply must be turned off.
Note
The optional service cards can be installed or removed while the DC power is supplied.
Installing Optional Service Cards
1. Insert the card along the guide rails.
2. Holding the card as shown below, push the release lever in the direction of the arrow so that the card
engages securely with the connector on the back board.
40 Installation Manual
2.2.6 Installing/Removing the Optional Service Cards
To Next Page
Loading...
